94
Step 2 Mechanical setup
Refer to the pictures on previous page.
To change the cutoff blades (“
C
”) loosen the “Cutoff Blade Clamping Screws” (marked “
D
”). at least
one full turn These screws can be accessed with the cut blades fully extended or full retracted. Support the
upper blade so it does not drop out. Cut blades must be fully retracted and the cutterhead full open to
remove the blades. Install the new blades with the proper cutting edge relationship. The upper cutting
edge faces to the right and the lower faces to the left. Tighten the “Cutoff Blade Clamping Screws”.
Manually close the cutterhead and insure the blades bypass freely with the cutting edges in contact with
each other.
