91
To change the cutoff blades (“
C
”) loosen the “Cutoff Blade Clamping Screws” (marked “
D
”). at
least one full turn These screws can be accessed with the cut blades fully extended or full
retracted. Support the upper blade so it does not drop out. Cut blades must be fully retracted and
the cutterhead full open to remove the blades. Install the new blades with the proper cutting edge
relationship. The upper cutting edge faces to the right and the lower faces to the left. Tighten the
“Cutoff Blade Clamping Screws”.
Manually close the cutterhead and insure the blades bypass freely with the cutting edges in
contact with each other.
INSTALLING THE PINCH BLADE
Pinch blade assembly number 5-144862
Replacement pinch blade 144811
STEP 1 Software setup
Click maintenance then click machine settings.
Select the Blade type to be Pinch blade
If this is the first use of this blade or the blade is not cutting properly see the next
section “Pinch blade calibration
