Artos CS-327, Owner'S Manual

Page: 50 / 133

50

Dress lead length is the length of wire that is cut of the leading end of the wire at the start of a
feed to justify the starting end of the wire. (min .5” - 12.6mm). For many devices if this length
is set too long or short, the justification piece will get stuck somewhere in the outfeed.
Items on the post process tab

Feed delay is the delay between parts to allow the post process to complete
o
None is no post process installed
o
CD11 - Artos twin coiling bowl device, CS326
o
CD15 - Artos pin coiler, CS326
o
CD15 with long lead - Artos pin coiler for use with non-standard table, CS327 only
o
AL – AL1500 to AL10000 linear collectors, CS326, CS327
o
MS type – Maxi-Seal custom unit CS326

Distance to guide

Distance to clamp
o
KRI – Ramatech model KRI-800 coiler with Omron 3G3MV motor control (older
version) , CS327
o
GR1 –
o
GR2 – Special coiler for Grundfos. GR1 and GR2 work in conjunction with each other.
When GR1 is selected as the Post process in the part properties window, the machine first
feeds out the length of wire programmed in GR1distance then waits for an input, then
feeds out the remainder of the programmed part length. When GR2 is selected as the Post
process in the part properties window, the machine first feeds out the length of wire
programmed in GR2 distance then waits for an input, then feeds out the remainder of the
programmed part length. CS327

GR1 distance – feeds this amount when GR1 is selected

GR2 distance – feeds this amount when GR2 is selected
o
CD16 - 3M collector - Artos 3 meter roll up collector. CS327
o
CD17 – Large coiling bowls - Artos large coiling bowl system, CS327
o
KRI-2 - Ramatech model KRI-800 coiler with Omron MX2-AB015-E motor control
(newer version), CS327
o
CP1250 – Schleuniger CP1250 coiling bowl. CS326
o
MINCO – Special process for Minco. CS326

Wait for A16 input

Feed the amount programmed in Feed 1 distance

Wait for A16 input

Feed the amount programmed in the Feed 2 distance

Wait for A16 input

Feed the remaining length of wire.
Label Configuration
A stand-alone printer is available for the CS 327 . This would allow you to print labels as you desire IE
by part, batch, or lot. This requires a specific printer and the associated software.
See section “LABEL PRINTING OPTION” for information for configuration and usage.