118
Cutter prox switch A22
‐
If there is a problem at this step go to the I/O screen and confirm this input turns on and off
when metal is presented in front of the sensor. If the switch is working then proceed to
trouble shoot the servo system using document “CS327 cutter Servo NIP.pdf”
Then it will slowly turn until the index mark on the motor is reached.
‐
If this step is not working then trouble shoot the servo system using docuement “CS327 cutter
Servo NIP.pdf”
Then it will move to the programmed home position.
‐
If the cutter opened up and hit the hard stop then you will need to calibrate the cutterhead.
3.
The outfeed gap stepper motor will reference. If the reference switch is on, the step motor will
move out until the switch (input A23) turns off. If the reference switch is off the step motor will
move in until the switch turns on. What this means is that the reference for the stepper motor is
edge sensing.
