Artesyn MaxCore MC1600, Installation And Use Manual, Page: 101 / 118

Software Configuration
MC1600 Extreme Edge Server Installation and Use (6806870A02A) 99
5.2.2 Baseboard Management Controller (BMC)
Hardware management and monitoring is accomplished via the BMC.
Sensors:
Sensors are read using the ipmitool utility with the command shown:
ipmitool sensor
CPU2 power state:
From the CPU1 command line the ipmitool utility is used to set the power state of CPU2 with
the following command:
ipmitool raw 0x2e 0x34 0xae 0 0 0x3 0x61 <power state>
The valid values for power state:
0: power down
1: power up
2: reset
5.2.2.1 IPMI OEM Commands
A list of IPMI OEM commands have been created to help with platform management in Table
5-4 Artesyn IPMI OEM Command Summary . This section documents the OEM commands with
the details specific to Extreme Edge Server, which may be different from other similar
platforms.
Artesyn IPMI OEM commands use the network function code 0x2E/0x2F, which is OEM/Group
according to the IPMI 2.0 specification.
Deviated from the IPMI specification, instead of the three-byte IANA number, the Artesyn OEM
commands use a single byte value 0xae as the identifier of the Artesyn OEM commands under
the net function group. Artesyn IPMI OEM commands also include an additional version byte
in the request message in case the requested data structure gets enhanced over time.
Therefore, a generic Artesyn IPMI OEM command must follow the
General OEM Command
Structure table shown next.