Artesyn MaxCore MC1600, Installation And Use Manual, Page: 85 / 118

System Installation
MC1600 Extreme Edge Server Installation and Use (6806870A02A) 83
4.3.6 Power Up
Before powering on the system, make sure that it was not stored where moisture could form
inside the unit. If it was, make sure the system is located in an environment in which it can
completely dry and reach room temperature before applying power.
The BMC automatically powers up the CPUs after it boots, this is the default. If the system is
changed from autonomous boot to power-button boot, then payload power must be enabled
manually. To manually switch on the main power, press
PWR at the Extreme Edge Server front
panel for a brief time. A tool similar to a pen or stylus is needed.
NOTE: Fans spin up and then spin down after a while. The main CPUs of the Extreme Edge
Server boot up. Allow booting to complete. Boot time may vary depending on
conditions.
4.4 Removal
The following subsections describe the procedures for removing the server from a rack or
cabinet.
4.4.1 Power Down the Server
For data integrity reasons Artesyn recommends to save data and close all applications before
power down.
Perform the server power down via the BMC's web interface or by pressing the power button
on the I/O panel. This guarantees a clean shutdown of all system circuitry.
Do not disconnect DC power to shut down the server. This may lead to improper startup
behavior when powering up again.
DC Power-Down Procedure
To power down the DC system, proceed as follows:
1. Power down the server using a system management software.
2. Remove power from the server using the external disconnect.
3. Verify that the power LED of the Extreme Edge Server is off.