Artesyn ATCA-7480, Installation And Use Manual, Page: 57 / 330

Hardware Preparation and Installation
ATCA-7480 Installation and Use (6806800T17A)
57
Installation Procedure
To install an MO297-A SSD module, proceed as follows:
1. Remove the blade from the system as described in Installing and Removing the Blade
on page 58 .
2. Plug the SSD module into the MO297-A connector. When inserting the MO297-A
module to the on-board connector, hold the on-board connector with two fingers
to prevent damage to the connector.
3. Fasten the SSD module to the blade using the screws supplied with the ACC kit.
4. Reinstall the blade into the system as described in Installing and Removing the Blade
on page 58 .
The additional resource (either memory or SATA SSD) will be detected
automatically during the boot-up sequence.
Damage of Circuits
Electrostatic discharge and incorrect module installation and removal can damage circuits
or shorten their life.
Before touching the module or electronic components, make sure that you are working in
an ESD-safe environment.