Artesyn ATCA-7480, Installation And Use Manual, Page: 158 / 330

Maps and Registers
ATCA-7480 Installation and Use (6806800T17A )
158
The IPMC Target Boot Flash selection will become active with next platform reset. When the
bits, TARGET_BOOT_SELECT and CURRENT_BOOT_SELECT are different, an alternate BIOS
needs to be selected. In this case the platform reset will be transformed by the FPGA logic to
payload power cycle including the ME. This is done to guarantee no SPI access to boot flash
when switching the other device.
Table 5-77 Flash Status Register
Address Offset: 0x40
Bit Description Default Access
0 CURRENT_BOOT_SELECT: Current Boot Flash
selection.
Is valid until next platform reset. 0 r
3:1 Reserved 0 r
4 TSOP or PLCC Boot select. Signal BOOT_TSOP.
0: TSOP selected
1: PLCC selected Ext.
0: SW1.3 OFF
1: SW1.3 ON r
5 Manual Boot Flash select enable. Signal
BOOT_SEL_EN_.
0: Signal BOOT_SELECT selects active boot flash
1: Switch SW3.2 selects the active Boot Flash. Ext.
0: SW3.1 OFF
1: SW3.1 ON r
6 Manual Boot Flash select. Signal BOOT_DEFAULT. Used
when SW3.1 is ON:
0: Selects Default Boot SPI Flash.
1: Selects Recover Boot SPI Flash. Ext.
0: SW3.2 OFF
1: SW3.2 ON r
7 TARGET_BOOT_SELECT. Target Boot Flash Selection.
0: Selects Default Boot SPI Flash
1: Selects Recovery Boot SPI Flash
Note: New flash selection valid with next platform reset PWR_GOOD:
0 LPC: r
IPMC: r/w