Artesyn ATCA-7480, Installation And Use Manual, Page: 125 / 330

Maps and Registers
ATCA-7480 Installation and Use (6806800T17A)
125
5.1.5 FPGA Register Mapping
5.1.5.1 LPC I/O Register Map
The FPGA registers can be accessed via LPC I/O cycles in the I/O address range REGISTERS. See
Table 5-38 FPGA Register Map Overview. For a LPC register access the host uses the base
address, 0x600. Individual registers can be accessed by adding an offset to the base address.
An LPC I/O write access to an address not listed in this table or marked with an “-” in the LPC I/O
column is ignored. A corresponding read access delivers always zero – used and reserved for
future extensions. A reserved register is read only and deliver always zero. A reserved bit is read-
only and always reads zero.
5.1.5.2 IPMC I2C Register Map
Some FPGA registers may be accessed via IPMC Private I2C transactions (Slave address 0x7F).
See
Table 5-38 FPGA Register Map Overview. An IPMC write access to an address not listed in
this table or marked with an “-” in the IPMC I2C column is ignored. A corresponding read access
delivers always zero. The address offsets not mentioned below are not used and reserved for
future extensions. A reserved register is read-only and always deliver zero. A reserved bit is
read-only and always reads zero.
LPC I/O Address = 0x600 + Address Offset
Table 5-38 FPGA Register Map Overview
LPC Address Offset LPC I/O IPMC I2C Description
0x00-0x01 r r Module Identification Register (See, Table 5-39 )
0x02 r r FPGA Version Register (See, Table 5-40 )
0x03 r/w r Serial Redirection Control Register (See, Table 5-41 )
0x04 r r/w Serial over LAN Control Register (See, Table 5-42 )
0x05 r r/w Serial Line Routing Register (See, Table 5-43 )
0x06 r r/w IPMC Power Level Register