Artesyn Embedded Technology ATCA-7370, Installation And Use Manual

Page: 179 / 252

Serial Over LAN
ATCA-7370/ATCA-7370-S Installation and Use (6806800P54G)
179
RMCP+ Cipher Suites : 1,2,3,3
Cipher Suite Priv Max : Not Available
root@localhost: ~#
7.4 Establishing a SOL Session
To start a SOL session, the following requirements must be fulfilled:

An Ethernet LAN connection to the onboard Gigabit Ethernet controller of the ATCA-7370
must exist.

ATCA-7370 IPMC firmware must correspond to version 2.0.1 and above.
Procedure
To establish a SOL session, proceed as follows:
1. Make sure that the requirements detailed above are fulfilled.
2. Compile and install the ipmitool on your target which is destined for opening the
SOL session on the ATCA-7370. For details refer to Installing the ipmitool on page
175 .
3. Apply an IP address to the ATCA-7370 SOL interface. For details refer to Configuring
SOL Parameters on page 176 .
4. If necessary change user and password.
Default user is "soluser" and password is "solpasswd".
5. Configure the network between the ATCA-7370 and your target, which is destined
for opening the SOL session, so that the SOL IP address is accessible.
MAC Address 00:00:00:00:00:00 means the address is shared between base and SOL
interface. The address can be found out in the MAC address record of the FRU.