29 of 36
EN
Cleaning the clearing system
Until a reasonable experience is acquired regarding the operating conditions, it is advisable to perform
this maintenance on at least a monthly basis.
• remove the electrical feed cable;
• remove the cap from the T-joint and proceed with the cleaning of the ducts. If necessary, at least for
the first few times, call in qualified personnel;
• carefully clean the smoke discharge system: for this, contact a professional chimney sweep;
• once a year clean the dust, cobwebs, etc. from the zone behind the internal covering panels, paying
particular attention to the fans.
Cleaning the fans
The pellet insert is furnished with fans (environmental and smoke) positioned at the rear and below the
pellet insert. Eventual deposits of dust or ash on the blades of the fan can cause an imbalance in the
fans leading to noisy performance. It is, therefore, necessary to clean the fans at least once a year.
Since said operation requires dismantling several parts of the pellet insert, have the fans cleaned only by
our Technical Assistance Centre.
Season end cleaning
At the end of the season, when the pellet insert will not be used for some time, it is advisable to perform
a thorough and general cleaning:
• Remove all the pellets from the container and the screw feeder;
• Carefully clean the brazier, the brazier support, the combustion chamber and the ash box.
Once the preceding points have been observed, it only means that the state of the pellet insert has been
verified. It is necessary to thoroughly clean the smoke discharge tube or flue and check the condition of
the basket. If necessary, order a new one from our Authorized Assistance Centre. If necessary, lubricate
the hinges of the door and the handle. Also check the ceramic fibre cord near the glass, on the internal
wall of the door; if it is worn or too dry, order a new one from the Authorized Assistance Centre.
Summary of Contents for NCA115-2A
Page 32: ...32 of 36 EN...
Page 38: ...38 of 36 EN NOTES...
