![background image](http://html1.mh-extra.com/html/arteche/satech-rio/satech-rio_user-manual_2977390017.webp)
WIRING
saTECH RIO
|
User´s
Manual | Rev. 1.0
17
6.3.2. Ethernet Ports
Communications via the rear of the unit are carried out, on request, either through two
Ethernet TX base ports with RJ45 connectors, or through FX base with ST-type fibre optic
connectors.
All the unit's network ports run at 10/100Mbps.
RJ45 Ethernet connection (following a request for the ETH RJ45 module).
The use of a UTP CAT5e cable is recommended.
A crossover or standard cable with RJ45
connectors can be used as the device has Auto-
MDIX.
Ethernet connection with fibre optic. (following a request for the ETH FO module).
ST Connector.
LC Connector.
A glass fibre optic cable with ST type connectors is to
be used.
Given the sensitivity of optical fibre cables, certain
precautions must be taken: Do not bend, the minimum
recommended curve radius for glass fibre cables is 25
cm. When connecting and disconnecting, always hold
the connector, not the cable. If using cable ties, make
sure not to overtighten. Failure to follow these
recommendations may result in internal damage not
visible to the naked eye which hinders or impedes
communications.
Summary of Contents for saTECH RIO
Page 1: ...saTECH RIO User s Manual...
Page 27: ...www arteche com Arteche...