33
Seal Ridge
Step 11: Roof Assembly
33H
Roof Panel
6
7743
Attach Panels #5 - #10 according to the diagram on page 30.
Weather Stripping Tape should be applied in
a continuous strip along the length of the roof.
You will need for this page:
(QTY: 8)
(QTY: 48)
Begin weather stripping the roof ridge. Apply more of
the
Weather Stripping
after each additional
Panel
is installed. A strip of
Weather Stripping Tape
2”
(5,1 cm) long should be applied over each
Bolt
that is on a
rib overlap and under the
Ridge Cap
.
1
3
Secure rib #5 with two
Small Bolts and Nuts
as
shown to the right, and then cover with two 2” (5,1
cm) strips of
Weather Stripping Tape
.
2
Attach the fi rst four
Panels
(#5 - #8) in the order
given in the diagram on page 30. Use the Roof Panel
Diagram on page 30 while assembling the roof. You
will need to ‘roll’ the
Panels
to secure the ribs together, just
as on
Wall Panels
.
•
Starting with rib #5 below, every rib that is over
a Truss should be secured with a Small Bolt and
Nut, and then sealed with a strip of Tape.
1
2
3
4
5
Install
Panels
#9 - #10 and seal with
Weather
Stripping Tape
.
4
Leave holes on ribs #1 and #2 open.
SB
SS
SB
SB
