1
Install three ridge caps on the
completed roof section using bolts
and nuts. Do not fasten the ends of
ridge caps until instructed to do so.
2
Fasten the remaining left and
right roof panels as you unroll the
weather stripping tape, and press it
down, install the second ridge caps
overlapping the fi rst ridge caps. Align
the holes and fasten using bolts and
nuts. Cover the notched areas of
the roof panels with strips of weather
stripping tape.
3
Fasten the lower end of the panels
to the side wall angles using screws
and washers. Use bolts and nuts
through wall angle overlaps at the
bottom of panel.
8742 Ridge Cap (6)
7953 Left Roof Panel (1)
7952 Right Roof Panel (1)
Step 15
M28
Parts Needed For
Ridge Caps & Panels
STEP
1
8742
STEP
8742
8742
8742
7953
STEP
3
7952
8742
8742
Cut
Weather Stripping
and Fold Under
2
28
1
Attach the side roof trim to the
lower end of the roof panels on each
side of the building using screws at
each panel overlap.
NOTE
A single screw fastens both trim
pieces at the overlap.
2
Using your thumb and index fi nger,
overbend the bottom fl ange of the side
roof trim at the corner inward enough
so the right and left roof trim caps fi t
onto right and left corners.
3
Fasten the roof trim caps to the
side trim using a screw.
4
Fasten the roof panel rib, peak cap
and ridge cap together using bolts
and nuts. Fasten the remaining peak
caps in the same manner.
8743 Side Roof Trim (4)
Step 16
M29
Parts Needed For
Roof Trim
STEP
1
8743
STEP
Peak Cap
Roof Trim
STEP
2
4
8743
8743
8743
Roof Trim Cap
Tuck Flange
Inward to Fit
Inside of
Roof Trim Cap
STEP
3
29
