1
Install a left roof panel at the left
rear corner of the roof.
2
Install four roof panels in the
sequence and positions shown on
previous page. Follow fastener se-
quence and instructions in Steps 13
thru 15 while fastening roof panels.
NOTE
Narrow roof panel rib (with bead
on it) is always overlapped by
wide rib of adjacent panel
3
Cut 26 short 3" (7,6 cm) strips off
the roll of weather stripping tape.
Cover the notches with the strips of
weather stripping tape. Save the
rest. Cover the joint at the peak
with weather stripping tape. Unroll
the tape and press it down over the
opening at the ridge as you install
each roof panel. Do not cut the tape
at this time.
NOTE
If roof beam holes do not line up
with the roof panel holes, shift the
building from left to right.
If this does not help, your building
may not be level. Shim the
corners until holes line up.
7953 Left Roof Panel (1)
7954 Roof Panel (4)
Step 14
M27
Parts Needed For
Roof Assembly
Weather Stripping Tape
Reducing Large Gable Bulge
Loosen eight bolts and nuts shown. Apply pres-
sure with one hand at the peak of the gable and
tighten bolt #1. Keeping pressure on the gable
work down the slope tightening each bolt. Excess
material will overlap smaller gable at seam. Once
material bulge is worked out tighten four vertical
bolts that connect the large and small gables.
7954
Roof Panel
STEP
STEP
#1
#2
#3
#4
3
2
Weather Stripping Tape
STEP
1
Screws To
Roof Beam
Screws To
Roof Beam
Do Not Fasten
At This Time
7953 Left Roof Panel
27
