!
8.1 Balancing Procedure
NOTICE
The TRINITY is a neutral balanced system every adjustment should be done carefully. Take
your time and do not over adjust any single axes.
Mount the Gimbal Handle onto the balancing pin.
Switch
ON
the Camera Power and Power ON the TRINITY stabilizer.
NOTICE
Make sure that you are in preset number
1
the fully free Mode.
Press the Mode Button once to confirm you are in preset
1
.
Bring the Trinity system into a horizontal position.
Check that the power and video cables have enough clearance to pass the yoke of the
TRINITY. If needed tape or strap the cable to the
camera body.
NOTICE
Turn the Fine Trim adjustment on the post to the
middle position.
Loosen the Gimbal locking clamp and move the Gimbal up and down the post by sliding and
rotating the gimbal on the post to reach a neutral horizontal position.
NOTICE
Try to keep the Center Post as short as possible. A short Center Post will give the TRINITY a
maximum of agility.
Turn the Fine Trim adjustment on the post to set the rig at absolute horizontal and
neutral balance.
26
