RDM c
o
mmand
s
44
Manufacturer commands
Lamp Hours
Shows the actual lamp hours of the fixture
X
Factory Defaults
This command deletes all user parameters and sets the fixture to factory default
X
X
Device Power Cycles
Shows the power cycle value, counts every cold start (switch or power-up)
X
Reset Device
Fixture makes a software reset (warm start) and carries out a reboot
X
X
Power State
Power state of the fixture, supported power states:
POWER_STATE_STANDBY (0x02),
POWER_STATE_NORMAL (0xFF),
POWER_STATE_FULL_OFF (0x00)
POWER_STATE_SHUTDOWN (0x01)
X
X
Perform Selftest
Supported test modes and demo modes
X
X
Self Test Description
Shows a description for each test / demo mode
X
Command
Description
GET
SET
RDM Fan Mode
PID: 0x8001
Changes the FAN mode of the fixture
- this message supports Set and Get commands
- the first data byte is used to show / change the fan mode
USER_FAN_MODE_LOW = 1
USER_FAN_MODE_VARI = 2
USER_FAN_MODE_HIGH = 3
X
X
RDM Status LED
PID: 0x8002
Switch on /off indication LEDs and LCD back light
- this message supports Set and Get commands
- the first data byte is used to switch indication LEDs on and off
LEDs and LCD back light on = 0
LEDs and LCD back light off = 1
X
X
Command
Description
GET
SET
