10
3.4 LMB 6x6 Tilt and Flex Adapter 80-156 mm
The Tilt and Flex Adapter is a flexible rubber donut compatible with lens diameters from
above 80 mm to less than 156 mm. It works perfectly with lenses where lens elements
are extending and can compensate the tilting angle when using the Swing Away Tilt
Modules from the LMB 6x6. An interface for both LMB 15 mm and LMB 19 mm Studio
Rod Adapters is integrated at the bottom.
Mounting Tilt LMB 6x6 Tilt and Flex Adapter 80-156 mm
• Open the grey screws at the left and the right side to unlock the clamp device (Fig. 1).
• Position the Tilt and Flex Adapter through the locking thumbscrews so it sits flush on
the filter stage (Fig. 2).
• Slide the clamp adapter upwards (Fig. 3).
• 2-stage version: Tighten the clamp adapter using the two grey locking thumbscrews
positioned sideways at the filter stages (Fig. 4).
• 3-stage version: Tighten the clamp adapter using the two black locking thumbscrews
positioned at the back of the filter stage (Fig. 5).
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Instructions