Arneg BADEN 90, Direction For Installation And Use

Page: 35 / 104

Baden
English
05060141 01 05-2022 33
2 - Use two hands at the same time (Ref. 13) to slide the top glass without force and
for a maximum distance of 20 cm (Ref. 14).
3 - Proceed to clean the surface as per instructions for glass parts.
4 - When done, restore the upper glass to its original position
5 - Refasten the hook of the glass panel
z
Curved glass (Rif. 15)
1 - Rotate the flywheel A clockwise (Rif. 16)
2 - Bring the glass at the right height to comfortably rotate the top curved glass
3 - Rotate the upper glass to allow cleaning tasks on the front glass
4 - Proceed to clean the front glass
5 - When done cleaning, restore the upper curved glass to its original position
6 - Rotate the flywheel A counter-clockwise
7 - Place the upper curved glass back on the side supports
18_5.Cleaning the parts in stainless steel
Certain situations can cause the formation of rust on the surfaces in steel:
z
iron remains left on damp surfaces, limestone, chlorine or ammonia based
detergents not rinsed properly, food incrustations or residues, salt-saline solutions,
dry residues of evaporated liquids.
Recent stains and rust:
z
clean with shampoo or neutral detergents, using a sponge or a rag. When finished,
eliminate any detergent residue, rinsing abundantly and thoroughly drying the
surfaces.
Old stains and rust:
z
use chemical substances on the stainless steel that contain 25% of nitric acid or
similar substances.
Die-hard stains and rust:
z
sandpaper or polish with a stainless steel brush. After this operation, wash with
detergents and carefully dry. This intervention may however cause scratches to the
surfaces due to the abrasive cleaning method.
18_6.Cleaning aluminium parts
18_7.Cleaning wooden parts
z
DO NOT use acid or alkaline detergents (e.g. bleach) which could corrode the surfaces
z
DO NOT use rough or abrasive materials or metal scrapers that could scratch
the aluminium surfaces
z
DO NOT use steam cleaning equipment
z
DO NOT use dirty cloths
z
Use a soft cloth with a neutral detergent or soap and lukewarm water (max 30°C).
z
Immediately remove all traces of water or detergent using a dry cloth in order
to prevent marks from forming.
z
DO NOT use acid or alkaline detergents (e.g. bleach), soda and solvents
which could corrode the surfaces
z
DO NOT use rough, abrasive materials which can scratch the surfaces
z
DO NOT use steam cleaning equipment
z
DO NOT use rough cloths
z
Moderate the use of liquid detergent: excessive use can cause infiltrations
between the panel and the edge, with possible swelling of the panel.