Arkray SE-1520, Operating Manual

Page: 80 / 91

b 5-02 ■ SE-1520
If an error occurs, an alarm sounds and the error message is displayed. Press
[STOP] key to stop the alarm. The error is cancelled and the Main Menu is displayed.
To avoid the recurrence of errors, confirm that the Main Menu is displayed and take
the proper measures described below. Confirm the condition, turn off the power and
contact your distributor.
T h e p i p e t t e w a s n o t r e m o v e d
within 8 seconds after pipetting.
Operation failure.
●
●
Remove the pipette within 5
seconds after pipetting.
●
E01
Description and error messages Problems and causes Remedy.
5-1
Error Messages
Chapter 5 Troubleshooting
4-1-1 お手入れの目安
Ｅ０１ Ｍｉｓｐｉｐｅｔｔｉｎｇ
ＯＫ（ＥＮＴＥＲ）
The plate is not set or set in the
opposite direction.
T h e b a r c o d e w a s n o t r e a d
correctly.
●
●
Wipe dirt off the table.
Make sure that foreign matter
is not adhered to the plate.
Set the plate correctly.
●
●
●
E05
Ｅ０５ Ｐｌａｔｅ Ｍｉｓｓ Ｓｅｔ．
ＯＫ（ＥＮＴＥＲ）
S y s t e m p o w e r w a s t u r n e d o f f
during measurement.
●
E10
Ｅ１０ Ｐｏｗｅｒ ｄｏｗｎ
ＯＫ（ＥＮＴＥＲ）
The correct plate is not set.
Item information is not registered.
Not read correctly.
●
●
●
Set the correct plate.
Check the setting items.
●
●
E15
Ｅ１５ Ｕｎｋｎｏｗｎ ｉｔｅｍ
ＯＫ（ＥＮＴＥＲ）
The Ｅ-plate was not disposed.
●
R e m o v e t h e E - p l a t e u s i n g
tweezers.
Check if the E-plate transfer
part is clean.
●
●
E16
Ｅ１６ Ｒｅｍｏｖｅ pｌａｔｅ
ＯＫ（ＥＮＴＥＲ）
Wear protective gloves to prevent exposure to pathogenic microbes.
Separate used samples, tips and protective gloves from general waste and dispose of them
according to local regulations on biohazardous waste.
Defective magnetic card.
Defective magnetic card reader.
●
●
Read the magnetic card again.
●
E20
Ｅ２０ Ｃａｒｄ ｍｉｓｒｅａｄ
ＯＫ（ＥＮＴＥＲ）