Arkray SE-1520, Operating Manual

Page: 23 / 91

b
This section explains the operation of analyzer, setting of
thermal printer paper and entering data and time.
Turn on the power to activate the plate transfer part to be set
at its ready position.
Turn on the power 1.
Turn on the power on the rear
of analyzer.
About 1 minute after (room
temperature at 25℃), warm-up
is completed and the MAIN
MENU is displayed.
●
●
Adjust the contrast of display 2.
Adjust the contrast of the display
by turning the contrast controller
on the rear of the analyzer.
To enhance the contrast, turn the
knob clockwise; to attenuate it,turn
it counterclockwise.
●
The name of analyzer and
i t s v e r s i o n n u m b e r a r e
d i s p l a y e d
a n d s e l f -
d i a g n o s i s s t a r t s i n 5
seconds.
T h e i n t e r n a l m e m o r y i s
c h e c k e d o n a b n o r m a l
conditions.
I f a n e r r o r o r a t r o u b l e
message appears on the
d i s p l a y , s o m e t h i n g i s
wrong with the internal
memory. Turn off the power
a n d
c o n t a c t y o u r
distributor.
The internal mechanisms
of analyzer are initialized.
Do NOT touch the plate
t r a n s f e r p a r t w h e n i t
moves. Otherwise it may
damage analyzer or cause
injury.
▲
▲▲
Set the Date and Time 4.
Set the date and time (see 3-6 Built-in Clock Adjustment )
●
Turn off the power 5.
Turn off the power after making sure that the MAIN MENU is displayed,
when discontinueing operation or setting after setting thermal printer
paper and setting the date and time.
●
Set thermal printer paper 3.
Set the attached thermal printer paper (see 4-3-1 Replacement of
Thermal Printer Paper ).
●
S P O T C H E M E L
S Eー1５2０ V１ . X X X
I n i t i a l i z i n g
…
/
W a r m i n g u p
…
/
１ . M e a s u r e ２ . S u b m e n u
３ . C a l .
（ １／１ ）
1-4
装置の設置
Chapter 1 Introduction
1-4-3 First Operation after Installation
SE-1520 ■ 1-15