Mobility support handle CM-ACC11 & CM-ACC12
The mobility support handle is used to
assist the patient in getting on or off the
bed. It is installed in the accessory socket
at the head end of the bed.
Two types are available: CM-ACC11 is
placed on the left side of the bed (when
viewed from the head end) and CM-
ACC12 is placed on the right side of the
bed.
The picture on the left shows CM-ACC12.
Installation
Insert the vertical pole of the mobility
support handle into the accessory socket
(A) on the appropriate side of the bed.
Make sure the mobility support handle
cannot rotate in the socket.
When correctly installed, the square base
of the pole (B) should fit tightly over the
top of the accessory socket.
Ensure that the mobility support handle is
angled away from the bed.
Pass the chain (C) behind the accessory
socket and install the retaining pin (D)
through the two holes at the base of the
vertical pole.
Make sure the mobility support handle
cannot be lifted out of the socket when
the retaining pin is installed.
Read the important safety
information on the next page.
A
B
D
C
746-574-AM-1
38
