3
Lay the head end panel section on the
floor with the two arms on the frame (C)
pointing outwards towards the right as
shown.
Position the bed so that you can work on
the underside of the mattress platform
whilst assembling the bed. This will make
it easier to connect the actuators to the
control box.
4
Slide the two side tubes of the head-end mattress platform section over
the arms on the head end panel assembly.
Place socket head screws into the two holes (D) on the underside of the
head end mattress platform and fix the sections together, installing the
bottom screw first. Tighten both screws firmly.
Use suitable packing material, e.g. cardboard, to raise the mattress
platform sections off the floor by about 1cm. This will help in aligning
the fixing holes correctly.
Unwind the power cord from around the slot (E) on the head end mattress
platform section.
WARNING
Take care not to pinch hands or fingers, or trap any cables, when
sliding the bed sections together.
C
D
E
D
746-574-AM-1
15
