Appendix - Scale Gravity Code Configurations
45
001
.25
06
0.E
N
re
v.
1
1
Whenever the MAXI MOVE floor lifts with scale
are sold in Europe, the conformity of the scale
with the requirements of the Council Directive 90/
384/EEC as amended, are established by tests
referred to in EN45501-8.2. This verification of
conformity is valid only for the location of use,
since the gravity has been adjusted prior to
delivery of the unit and sealed by the calibration
and gravity counter on the scale marking.
A two-digit gravity code is assigned to the scale
according to the geographical location where it
will be used. This code can be viewed by
following the step outlined below.
NOTE: When the preset code is 99, it means that
the scale has been adjusted to the exact latitude
and altitude corresponding to the specific
geographical location where it will be used.
NOTE: Gravity codes cannot be changed using
the operating menu. Contact your ArjoHuntleigh
representative for more information.
Appendix - Scale Gravity Code Configurations
STEP 1
To display the Hoist
Status Screen,
press both
operating buttons at
the same time.
STEP 2
Once in the Hoist
Status screen,
press on the enter
button.
STEP 3
Press the down
button three times
to find the Gravity
Codes settings.
STEP 4
To return to normal
scale function,
press the exit
button.
Viewing the Gravity Code Configuration
Operating
buttons
Enter button
Down button
Gravity code
Elevation and
latitude (only
for code 99)
Calibration counter
value
Gravity counter
value
Exit button
