ARI-Armaturen ARI-PACO 2G 1,6 D, Operating And Installation Instruction

Page: 39 / 41

0040506004 0919 Page 2-39
Operating and installation instructions
Thrust actuator ARI-PACO
®
2G 1,6D/Y
9.2.1 LED-Failure signals according to Namur NE107
Warnings and information messages (blue, yellow or orange LEDs) do not interrupt the control
mode!
9.2.2 LED-Failure-encoding
NE 107 Colour Namur description ARI-PACO
®
2G 1,6kN Y
Maintenance required Blue Urgent maintenance required
Maintenance required Dirty slide -
clean slide
Out of specification Yellow Out of specification, unsafe due
to environmental and process
influences - CDF exceeded
- Max. hysteresis
- Supply voltage / frequency out
of tolerance Toleranzen
- Overheating
- Moisture: Heating has been on
for longer than 1 h
Function check Orange Configuration change, local
operation, substitute value - Manual mode / local operation
The actuator is controlled by the
handwheel or locally
- Blockage detected
Failure Red Internal failure
Process failure - Y
in
interrupted
- Blockage - the desired position
can no longer be approached
- Checksum error
- Gear motor damage
- Actuator separated from valve
(yoke broken, valve stem, etc.)
- Valve stem blocked in both
directions
- Actuator is not initialized yet
No initialization run Green Red
Blockage Green Red Orange
Y
in
control signal failure Green Red Yellow
ADV - outside the travel path Green Red Orange Yellow
Position kann nicht erreicht werden Green Red Orange Blue
Position can not be achieved Green Red Orange Yellow Blue
Motor error Green Red Blue