Page 2-18
0040506004 0919
Operating and installation instructions
Thrust actuator ARI-PACO
®
2G 1,6D/Y
5.4.2 Installation Options
5.4.2.1 Trip slide and setting of S3.
5.4.2.1.1 Installation procedure
- Switch-off mains voltage and safeguard to prevent it from being switched back on again
accidentally.
- Loosen collar nut screw on hood, carefully remove hood.
- Disconnect motor plug and mains connection plug from board.
- Screw the hexagon nut M5 (pos. 50.39) approx. 6mm on the guide spindle (pos. 50.38).
- Screw the guide spindle in accordance with setting dimension (see Fig. 5) into the drive spindle
(pos. 50.30) and counters with the hexagon nut M5.
- Lubricate trip slide (pos. 50.50) at the bearing surface ends with grease.
- Push trip slide (pos. 50.50) into board support (pos. 50.42) from above and onto the guide spindle
(pos. 50.38).
- Mount the trip slide (pos. 50.50) so that the guide spindle (pos. 50.38) is centrally situated in the
borehole of the trip slide and the spring (pos. 50.56) clips into the 2. groove of the guide spindle.
- Insert motor connection plug in jack strip (pos. 50.43.4) provided for the purpose.
Fig. 5: Spindle and trip slide installation
Pos.
Designation
Pos.
Designation
50.30
Driving spindle
50.51
Setting spindle for switch S3
50.38
Guide spindle
50.52
Setting spindle for switchS4
50.39
Hexagon nut DIN EN ISO 24034 - M5
50.53
Setting spindle for switch S5
50.42
Board support
50.54
Trip cam
50.50
Trip slide (option)
50.56
Spring for trip slide
Grooves for
springh
1. Groove for spring
2. Groove for spring
