INSTALLATION & ASSEMBLY INSTRUCTIONS
6
DISCLAIMER
ALL INFORMATION AND THE TECHNICAL SPECIFICATIONS PRESENTED IN THIS USER’ S MANUAL ARE THE
PRESENTATION OF THE MANUFACTURE . PLEASE READ AND FOLLOW THESE INSTRUCTIONS CAREFULLY .
TOOLS NEEDED:
• Phillips Screw Driver
• Drill (If pilot holes are needed)
Window preparation
1 . This air conditioner is designed to be installed In
a standard double-hung window with a window
width between 23″ and 36″ (660mm-914mm).
2 . The air conditioner can be installed without the
accordion panels fit in a narrow window opening.
3 . The lower sash ( the lower part of the window
that moves up and down) must allow for 16” of
vertical clearance when open .
4. All supporting parts must be secured to firm
wood, masonry, or metal .
5 . The electrical outlet must be within reach of the
power cord .
How to Install
NOTE: This is necessary for proper condensation utilization
and drainage. If you are not using the Side Panels for any
reason, this pitch to the rear must be maintained!
Remove the air conditioner from the box and place
it on a hard flat surface, such as a floor, bench, or
table . There is a Left and Right Window Accordion
Panel - be sure to use the proper panel for each side .
When installed the flange for securing the panel in
place to the window sill will be facing into the room .
OFFSET
STOOL
SILL
INTERIOR
WALL
EXTERIOR
WALL
Air conditioner
Bottom channel
NOTE: Save the product packaging and installation instructions
for future reference. Store the air conditioner in the product
box when not in use for an extended period of time.
CAUTION
When handling unit, be careful to avoid cuts
from sharp metal edges and aluminum fins
on front and rear coils .