81
E
8. Using a FOX nitrogen safety needle, press it
through the rubber pellet to depressurize the nitro-
gen charge. When the shock is fully discharged,
pull the needle away in a straight, smooth motion.
NOTE: At this point, inspect the nitrogen valve
for signs of wear such as holes on the face of the
pellet. Replace if necessary.
F
9. Press down on the reservoir end cap; then using a
scribe or a pick tool, remove the reservoir snap
ring. Pull the end cap out of the reservoir.
G
H
10. Using a 5/64-in. hex key, carefully loosen the
bleed set screw; then remove the ball bearing and
set it aside.
I
NOTE: It is advisable to use a small magnet to
remove the ball bearing from the hole.
