71
RA031A
4. Remove the pin and allen-head screws securing
the brake caliper halves together; then remove the
retaining ring securing the brake disc. Remove the
brake disc.
RA032A
RA030A
5. Remove the cap screws securing the slide rail
assembly.
NOTE: At this time, it is recommended to have
the snowmobile tipped on the left-side.
6. Remove all torx-head screws securing the chain
case cover. Remove cover.
7. Loosen the jam nut and the chain tensioner enough
to remove the chain and sprockets; then remove
the chain and sprockets. Remove chain lube oil.
0747-877
RA013
8. Remove the cap screws securing the inner caliper to
the tunnel; then remove the inner caliper and bearings.
NOTE: It may be necessary to use Puller Tool (p/n
0744-067) to remove the caliper/bearing assembly.
PC148A
9. Pull the driveshaft out to the left; then drop out of
tunnel right side first.
NOTE: At this point, inspect the bearings for
wear or roughness. Replace as necessary.
