54
NOTE: Secure the connecting rods with rubber
bands on the cylinder studs.
16. With a new O-ring, install the oil-injection pump
retainer; then install the cover plate and gasket.
RS037
RS036A
17. Position the ceramic/rubber seal into the back side
of the water pump impeller with the ceramic face
of the seal directed out.
CM168
18. Using both thumbs, press the seal into position
making sure its marked side is positioned towards
the rubber seal cup; then apply a thin coat of
grease to the seal outer surface.
CM169
19. Place the impeller into position and secure with a
cap screw and washer. Be sure the rubber side of
the washer is directed toward the impeller. Apply
blue Loctite #243 to the threads of the cap screw
and tighten to 96 in.-lb.
NOTE: For assembling purposes, it is advisable
to lubricate the rubber side of the washer before
installing.
20. Apply high-temperature sealant to the crankcase/
water pump cover seam; then install the dowel
pins into the crankcase.
FC133A
NOTE: It is important to not get sealant into the
breather hole in the crankcase. If sealant gets into
the hole, carefully remove before proceeding.
CAUTION
When installing the seal into the impeller, assure that
all components are clean and free of any dirt or other
contaminants.
CAUTION
The rubber side of the washer, which secures the
impeller, must be positioned toward the impeller. If
installed incorrectly, a coolant leak will result.
