MAINTENANCE
83
741-329A
Installing Headlight
Bulb (F-Series/Jaguar
Z1/T-Series/TZ1
Models)
1. Plug the wiring harness into the
headlight bulb.
2. Insert the bulb into the headlight
housing.
3. Lift the front of the console
enough to allow the headlight
housing to be installed; then
install the housing making sure
the forks of the housing go into
the grommets on top of the air-
intake silencer. Secure with the
cap screw and lock nut.
741-505A
4. Position the console onto the air-
intake silencer; then secure with
the single torx-head cap screw
beneath the console (located
between the headlights).
5. Install the two torx-head cap
screws located to the outside of
the headlight adjustment knobs;
then tighten securely.
6. Check headlight aim (see Adjust-
ing Headlight Aim in this sub-
section).
Adjusting Headlight
Aim
The headlight can be adjusted for ver-
tical aim of the HIGH/LOW beam.
The geometric center of HIGH beam
zone is to be used for vertical aiming.
1. Position the snowmobile on a
level floor so the headlight is
approximately 8 m (25 ft) from an
aiming surface (wall or similar
surface).
NOTE: There should be an
“average” operating load on the
snowmobile when adjusting head-
light aim.
2. Measure the distance from the
floor to midpoint of the headlight.
3. Using the measurement obtained
in step 2, make a horizontal mark
on the aiming surface.
4. Make a vertical mark which inter-
sects the horizontal mark on the
aiming surface directly in front of
the headlight.
! CAUTION
Do not touch the glass portion of
the bulb. If the glass portion is
touched, it must be cleaned with a
dry cloth before installing.
! WARNING
Do not operate the snowmobile
unless headlight beam is adjusted
properly. An incorrectly adjusted
beam will not provide the operator
the optimum amount of light.
