GENERAL INFORMATION
21
0734-406
2. Adjust the handlebar up or down
to operator’s desired tilt; then
tighten the lock nuts evenly and
securely. Check steering for maxi-
mum right/left turning capabilities.
3. Recheck lock nuts; tighten
securely.
NOTE: Recommended torque
value of lock nuts is 2.5 kg-m (18
ft-lb).
NOTE: Do not adjust the handle-
bar to a position that allows the
brake fluid to be below the low
mark on either side of the master
cylinder.
HANDLEBAR TILT
(F-Series/T-Series -
STD Models)
The handlebar can be adjusted to the
operator’s preference. To adjust the
handlebar, use the following proce-
dure:
1. Loosen the eight cap screws
securing the handlebar caps to the
riser and the riser to the steering
post.
735-501B
2. Adjust the handlebar up or down
to operator’s desired tilt, tighten
the cap screws evenly to 3.5 kg-m
(25 ft-lb), and check steering for
maximum right/left turning capa-
bilities.
NOTE: Do not adjust the handle-
bar to a position that allows the
brake fluid to be below the low
mark on either side of the master
cylinder.
HANDLEBAR TILT
(LXR/Sno Pro/Jaguar
Z1/TZ1 Models)
The handlebar can be adjusted to the
operator’s preference. To adjust the
handlebar, use the following proce-
dure:
1. Press inward on the lock pin to
release the cam lever and “flip”
the cam lever up.
! WARNING
Tighten lock nuts according to
specifications to prevent unex-
pected “movement” of the handle-
bar during operation over rough
terrain and DO NOT position han-
dlebar so steering (maximum right/
left turning capabilities) or throttle
and brake controls are affected.
! WARNING
Tighten cap screws according to
specifications to prevent unex-
pected “movement” of the han-
dlebar during operation over
rough terrain. DO NOT offset the
handlebar so steering (maximum
right/left turning capabilities) are
altered or throttle and brake con-
trols will be affected.
