MAINTENANCE
79
Overload Springs
Some models have overload springs
built into the rear suspension. When
either carrying a heavy load or riding
2-up, the overload springs should be
engaged by rotating the spring tension
blocks to the UP position. The spring
tension blocks lock in an over-center
position when engaged. To either
engage or disengage the spring tension
blocks, use the Spring Block Tool, a
spark plug socket, and a screwdriver
to adjust the spring block to the
desired position. Make sure both
spring blocks are in the same position
(either engaged or disengaged).
0739-625
LIGHTS
For the correct headlight bulb and/or
taillight/brakelight bulb, see the
appropriate specifications sheet.
Removing and
Installing Taillight/
Brakelight Bulb
(Bearcat/Panther/
T660 Models)
1. Remove the screws securing the
taillight/brakelight lens; then
remove the lens.
728-384C
2. Push in on the bulb and rotate it
counterclockwise to remove it
from the socket.
3. Install the new bulb in the socket
by pushing it in and rotating it
clockwise.
4. Install the lens and secure with
the screws.
Removing and
Installing Taillight/
Brakelight Bulb
(Crossfire/F-Series/
Jaguar Z1/M-Series/T-
Series/TZ1 Models)
1. On the F-Series/Jaguar Z1/TZ1
models from inside the rear storage
compartment, remove the self-tap-
ping screws and washers securing
the taillight/brakelight housing.
741-680A
2. On the Crossfire/M-Series mod-
els, remove the machine screw
securing the taillight/brakelight
housing to the rear bumper; then
remove the two self-tapping
scrws and washers securing the
taillight/brakelight to the housing.
