42
LUBRICATION
NOTE: If excessive oil deposits
are noticed, take the snowmobile
to an authorized Arctic Cat Snow-
mobile dealer for service. If not
under warranty, this service is at
the discretion and expense of the
snowmobile owner
.
F5/F 570 - T500/T570
742-476A
F-Series 6/8/1000 -
Jaguar Z1/TZ1
0741-334
Crossfire/M-Series
741-636A
3. Tip the snowmobile onto its right
side and place a piece of card-
board underneath to protect the
finish on the hood and belly pan.
NOTE: It is recommended that
the gas tank be nearly empty (less
than 1/4 full) when tipping the
snowmobile.
4. Remove the drain plug from the
gear case; then install a drain
adapter fitting with hose into the
drain plug hole.
NOTE: To aid in draining the
lubricant, it is advisable to fashion
a drain adapter by acquiring a fit-
ting and a length of 3/8-in. hose.
5. Tip the snowmobile back to the
upright position; then place a
drain pan on the floor next to the
drain hose and tip the snowmobile
toward its left side far enough to
allow the lubricant to drain from
the gear case into the drain pan.
NOTE: It is critical that the
snowmobile is on a level surface
to ensure the lubricant drains
properly and completely.
6. Secure the snowmobile in this
position until the lubricant is
completely drained.
7. When the lubricant has com-
pletely drained form the gear
case, tip the snowmobile back to
the upright position, remove the
drain adapter, and install and
securely tighten the drain plug;
then remove the check/fill plug.
8. Pour the recommended amount of
Arctic Cat ACT Gear Case Flush
(p/n 4639-333) into the check/fill
hole; then install the plug. Tighten
securely.
! CAUTION
It is critical that all of the old lubri-
cant be drained from the gear
case prior to flushing the gear
case.
! CAUTION
Do Not add more or less than the
recommended amount of flush
fluid to the gear case.