Arctic Cat bearcat 2000l bearcat 3000, Operator'S Manual

Page: 62 / 72

58
2. Remove the cap screw and lock nut
securing the front of the headlight
assembly to the air-intake silencer.
3. Lift the front of the console enough
to allow the headlight housing to be
removed; then remove the housing.
4. Remove the bulb from the headlight
housing and disconnect the wiring
harness from the bulb.
741-329A
1. Plug the wiring harness into the
headlight bulb.
2. Insert the bulb into the headlight
housing.
3. Lift the front of the console enough
to allow the headlight housing to be
installed; then install the housing
making sure the forks of the housing
go into the grommets on top of the
air-intake silencer. Secure with the
cap screw and lock nut.
743-439A
4. Position the console onto the air-intake
silencer; then secure with the single
torx-head screw beneath the console
(located between the headlights).
5. Install the two torx-head screws located
to the outside of the headlight adjust-
ment knobs; then tighten securely.
6. Check headlight aim (see Adjusting
Headlight Aim in this sub-section).
3000/7000

NOTE: The bulb portion of head-
light is fragile. HANDLE WITH CARE.
When replacing the headlight bulb,
the bulb assembly must first be
removed from the housing. Do not
touch the glass portion of the bulb. If
the glass is touched, it must be
cleaned with a dry cloth before
installing.
1. Disconnect the headlight harness
connector from the bulb; then
remove the rubber grommet from
the headlight housing.
2. Rotate the bulb retainer counter-
clockwise until it unlocks from the
housing; then remove the bulb.
0746-096
3. Install the bulb and retainer; then
rotate the retainer clockwise until it
properly locks in place.
4. Install the rubber grommet; then
connect the headlight harness con-
nector to the bulb.
CAUTION
Do not touch the glass portion of the
bulb. If the glass portion is touched, it
must be cleaned with a dry cloth
before installing.
! WARNING
Do not operate the snowmobile
unless headlight beam is adjusted
properly. An incorrectly adjusted
beam will not provide the operator
the optimum amount of light.