30
3. Remove the actuator extension; then
re-install the actuator extension
making sure the notch in the exten-
sion is directed downward.
4. Install spring into the bottom of
detent block and install into the
chain case cover. The notch in the
extension should be lined up with
the notch in the block.
NOTE: Rotate the extension clock-
wise approximately 20° making sure
not to pull out the extension when
rotating. This is only to aid in the
installation of the actuator.
5. Install the actuator and secure using
the existing three torx-head screws.
Tighten to 36 in-lb.
6. Connect the harness to the gear posi-
tion sensor; then secure the connec-
tor to the main harness using a cable
tie.
0748-259
7. Start the engine and verify proper
reverse and forward operation by shift-
ing in and out of reverse three times.
NOTE: If excessive build-up of
moisture or discolored oil is
detected in the chain case, it may be
necessary to replace the lube.
Transmission (7000)
NOTE: The snowmobile must be
on a level surface for this procedure.
It is very important that the transmission
be flushed and the lubricant be replaced
after each season of use. Arctic Cat rec-
ommends that the flushing and replacing
be done prior to off-season storage.
NOTE: Flushing the transmission
and replacing the lubricant can be
done by the snowmobile owner if
qualified to do so. If the owner does
not feel qualified, take the snowmo-
bile to an authorized Arctic Cat
Snowmobile dealer for this service.
This service is at the discretion and
expense of the snowmobile owner
.
To flush the transmission and replace the
lubricant, use the following procedure:
1. Open the hood and remove the right-
side access panel.
2. Remove the drain plug from the trans-
mission cover; then allow all lubricant
to drain into a suitable container.
0749-026
NOTE: It is critical that the snow-
mobile is on a level surface to
ensure the lubricant drains properly
and completely.
3. When the lubricant has completely
drained, install and securely tighten the
drain plug; then remove the fill plug.
4. Pour Arctic Cat ACT Drive Flush
Fluid (p/n 4639-333) into the fill
plug hole; then install the plug.
Tighten securely.
5. Install the right-side access panel
and close the hood.
6. Using a shielded safety stand, raise the
rear of the snowmobile off the floor
making sure the track is free to rotate.
! WARNING
DO NOT stand behind the snowmo-
bile or near the rotating track. NEVER
run the track at high speed when the
track is suspended.
