13
7000
Handlebar Tilt
3000/7000
1. Loosen the four lock nuts securing
the handlebar caps and block to the
steering post.
0745-848B
2. Adjust the handlebar to operator’s
desired tilt; then tighten the cap
screws evenly and securely to 15 ft-
lb. Check steering for maximum
right/left turning capabilities.
NOTE: Do not adjust the handlebar
to a position that allows air to enter
the brake system.
2000
The handlebar can be adjusted to the
operator’s preference. To adjust the han-
dlebar, use the following procedure:
1. Loosen the four cap screws and lock
nuts securing the handlebar caps to the
riser and the riser to the steering post.
Code
Trouble
P0031 O2 Heater Control Circuit Low
P0032 O2 Heater Control Circuit High
P0107 Manifold absolute pressure circuit low
P0108 Manifold absolute pressure circuit high
P0112 Intake air temp sensor circuit low
P0113 Intake air temp sensor circuit high
P0115 Engine coolant temp sensor 1 circuit
P0117 Engine coolant temp sensor 1 circuit
low
P0118 Engine coolant temp sensor 1 circuit
high
P0120 Throttle position sensor circuit
P0122 Throttle position sensor circuit low
P0123 Throttle position sensor circuit high
P0130 O2 sensor circuit
P0131 O2 sensor circuit low
P0132 O2 sensor circuit high
P0171 System too lean
P0172 System too rich
P0201 Injector circuit/open - cylinder 1
P0202 Injector circuit/open - cylinder 2
P0203 Injector circuit/open - cylinder 3
P0217 Engine coolant over temp condition
P0261 Cylinder 1 injector circuit low
P0264 Cylinder 2 injector circuit low
P0267 Cylinder 3 injector circuit low
P0508 Idle air control system circuit low
P0509 Idle air control system circuit high
P0511 Idle air control circuit
P0522 Engine oil pressure sensor circuit low
P0523 Engine oil pressure sensor circuit high
P0562 System voltage low
P0563 System voltage high
P0780 Shift Error
P1315 Crankshaft Position out of sync
P1338 Crankshaft spike detected
P1339 Crankshaft tooth not detected
P1685 Main relay open circuit
P1686 Main relay circuit low
P1688 Reverse relay open circuit
P1689 Reverse relay circuit low
P1691 Forward relay open circuit
P1692 Forward relay circuit low
P1694 Headlight relay open circuit
P1695 Headlight relay circuit low
P2228 Barometric pressure sensor A circuit
low
P2229 Barometric pressure sensor A circuit
high
P2300 Ignition coil A primary control circuit
low
P2303 Ignition coil B primary control circuit
low
P2306 Ignition coil C primary control circuit
low
U1000 Vehicle not registered or invalid PIN
U1001 Vehicle not registered and vehicle lim-
its enabled
U0155 Lost communication with the ECM
! WARNING
Tighten cap screws according to speci-
fications to prevent unexpected “move-
ment” of the handlebar during operation
over rough terrain. DO NOT position
handlebar so steering (maximum right/
left turning capabilities) or throttle and
brake controls are affected.
