187
WC012A
WC110B
2. Turn the left-side and right-side tie rods in equal incre-
ments to achieve the proper toe-out; then tighten the
jam nuts to 10 ft-lb.
Hood
WC078D
REMOVING
1. Remove two fender screws (A) and two machine screws
(B) with washers from the grille and remove the grill.
2. Remove two side fender screws (C), one on left and
one on right located above and behind the headlight
assemblies.
3. Reach up through the front fender wells and remove
two fender screws (D) from the rear of the hood and
remove the hood.
INSTALLING
1. Lay the hood in place on the frame; then install the
rear fender screws (D).
2. Install the two side fender screws (C); then place the grille
on the vehicle and install the two machine screws (B) and
fender screws (A). Tighten all fasteners securely.
Rear Body Panel
REMOVING
1. Remove the seats; then remove the machine screws
securing the rear body panel to the frame and rear
splash panel.
WC346A
WC347A
2. Remove the hose clamp from the gasoline filler neck
and disconnect the filler hose.
CAUTION
Always use a wrench to hold the tie rod ends when loos-
ening or tightening the jam nuts or damage to the boots
could occur.