Arbor Technology M1922, User Manual

Page: 72 / 90

- 56 -
BIOS
4.3.3 SATA Configuration
Access this submenu to view SATA device(s) information and also to configure
SATA device(s).
SATA Controller(s) [Enabled]
SATA Mode Selection [AHCI]
SATA Controler Speed [Default]
Serial ATA Port 0 INTEL SSDSC2BB (80.0GB)
Software Preserve Supported
Port 0 [Enabled]
SATA Device Type [Hard Disk Drive]
Serial ATA Port 1 Slimtype DVD A ATAPI
Software Preserve N/A
Port 1 [Enabled]
SATA Device Type [Hard Disk Drive]
Serial ATA Port 2 mSATA-I50 (32.0GB)
Software Preserve NOT SUPPORTED
Port 2 [Enabled]
SATA Device Type [Hard Disk Drive]
Serial ATA Port 3 Empty
Software Preserve Unknown
Port 3 [Enabled]
SATA Device Type [Hard Disk Drive]
Enable or disable SATA Device.
Version 2.15.1236. Copyritght (C) 2012 American Megatrends, Inc.
Advanced
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
: Select Item
: Change Opt. +/-
: Previous Values F2
: General Help F1
: Save & Exit F10
: Exit ESC
: Select Screen
: Select Enter
: Optimized Defaults F9
The SATA Configuration screen provides the following setting options:
Settings Descriptions
SATA Controller(s)
Enables/disables the present SATA controller.
Options:
Enabled
[default],
Disabled
SATA Mode Selection
Configures how SATA controller(s) operate.
Options:
IDE and AHCI [default].
SATA Controller
Speed
Sets the maximum speed for the SATA controller to
support. This setting is available only when SATA Mode
Selection is set to AHCI .
Options:
Default
[default],
Gen1
,
Gen2
and
Gen3
.