Arbor Technology M1922, User Manual

Page: 78 / 90

- 62 -
BIOS
Settings Descriptions
USB hardware
delay and time-out
This is a submenu to configure the features of USB hardware
delay and time-out. The settings include:
USB Transfer time-out: Use this item to set the time-out
value for control, bulk, and interrupt transfers.
Options: 1 sec, 5 sec, 10 sec, 20 sec [default]
Device reset time-out: Use this item to set USB mass
storage device start unit command time-out.
Options available are: 10 sec, 20 sec [default], 30 sec, 40 sec
Device power-up delay: Use this item to set maximum time
the device will take before it properly reports itself to the host
controller. ‘Auto’ uses default value: for a root port it is 100 ms,
for a hub port the delay is taken from hub descriptor.
Options:
X
Auto
[Default]
X
Manual : Select Manual you can set value for the following
sub-item: ‘Device Power-up delay in seconds’, the delay
range in from 1 to 40 seconds, in one second increments.
Mass Storage
Devices
Use this item to select mass storage device emulation type.
Auto enumerates device according to their media format.
Optical drives are emulated as “CD-ROM”. Device with no
Media will be emulated according to a drive type.
Options:
Auto [Default], Floppy , Forced FDD , Hard-Disk ,
CD-ROM