Figure 5 Drip Loop
Installation of UV Disinfection System
3.
Mount the system to the wall using the supplied clamps. Various connection methods can be used to connect the water
source to the system.
Note:
Flow
Figure 4 Flow Restrictor
DO NOT solder connections while attached to the system as this could damage the O-ring seals.
4.
Mount the VIQUA ICE controller horizontally to the wall, near the chamber. Ideally place the controller above the reactor
and away from any water connection point, to prevent any water from potentially leaking onto the controller by means of
a leak at a connection point or a “sweating” system. Make sure you allow for a “drip-loop” as shown in
Figure 5
on the
lamp, and power cord, again, to prevent any water from potentially entering the controller.
5.
Install the UV lamp. Refer to
Section 4.1
.
6.
When all plumbing connections are complete, slowly turn on the water supply and check for leaks. The most likely cause
for leaks is from the O-ring seal. In case of a leak, shut water off, drain cell, remove the retaining nut, wipe the O-ring
and threads. Clean and re-install.
Figure 3 Disinfection Installation - Vertical and Horizontal
A
B
7
Summary of Contents for SC200-A
Page 1: ...Owner s Manual Powered by Models SC200 A SC410 A 520192 R_RevK...
Page 15: ...Supporter par Mod les SC200 A SC410 A Manuel d utilisation Supporter par 520192 R_RevK...
Page 29: ...Desarrollado por Modelos SC200 A SC410 A Manual del propietario Desarrollado por 520192 R_RevK...
Page 43: ...43 Esta p gina est en blanco de forma intencional...
