background image

2

INTRODUCTION & DESCRIPTION CHANGES

Thank you for purchasing the AquaCraft

®

 Minimono! We want the 

time you spend with your new RC boat to be fun and successful so 
please fully read the manual. If for any reason you think this model 
is not for you, return it to your local dealer immediately. 

NOTE: Your 

hobby dealer cannot accept a return on any model after final 
assembly or after your boat has been subject to operation.

All pictures, descriptions, and specifications found in this instruction 
manual are subject to change without notice. AquaCraft maintains 
no responsibility for inadvertent errors in this manual.

ITEMS INCLUDED

Minimono Brushless Boat

Hatch Tape

Tactic

 2.4GHz Transmitter

Extra Prop

Boat Stand

Extra Rudder O-Ring

PARTS NEEDED TO COMPLETE YOUR MODEL

GPMP0830 3S LiPo Battery 1000

 

mAH 30C

GPMM3318 3S LiPo Balancing Smart Charger

AA Dry Cell Batteries (4)

HIGHLY RECOMMENDED: LiPo Sack (GPMP0751) 

Other Battery and Charger choices:

❏  

FPWP2133 LiPo FP25 3S 11.1V 1300mAh 25C

❏  

DTXP4195 Onyx 150 AC/DC LiPo Balancing Charger

OPTIONAL PARTS

 AQUB9500 Speed Grease

 DTXR0288 1.5mm Hex Wrench

 AQUB9514 GrimRacer

 Pro Radio Box Tape

 GPMM3210 Great Planes CellMatch

 DTXR0289 Duratrax Ultimate Hex Driver 2.0mm

 AQUB7731 AquaCraft 31mm FRP Propeller Blue

IMPORTANT LIPO PERFORMANCE

AND CARE INFORMATION

To get the most performance and safety from your LiPo battery, 
please read and understand the following information.

CHARGING: 

For best performance and longest battery life, never 

charge your LiPos at a charge rate higher than 1C. (1000mAh = 
1amp). Never charge your battery pack in the model and always 
place your battery in a safe charge container like a LiPo Sack 
(GPMP0751) or other safe charge container when charging.

DISCHARGING OR OPERATION: 

We have found it best to use only 

80% of the rated mAh of the battery pack per discharge (boat run). 
You will experience rapid depletion of battery pack performance if you 
continue to discharge your packs below the 80% usage target. In the 
stock configuration and on smooth water you will find your Minimono 
will use around 200 to 225mAh per minute of operation during wide 
open operation. On rough water your Minimono will use around 180 
to 200mAh per minute. Keep this in mind as you adjust your run 
times. 

NOTE:

 Your AquaCraft Minimono’s Motor Controller has a 

stutter bump warning system that warns you of low battery voltage. 
This system starts its warning at or around 9.6V total, giving you 
time to bring the boat back to shore before the motor controller cuts 
off at 9V total. This is a built in safety system for you, your boat and 
your batteries. Although this system is in place we still recommend 
adjusting your run times to not exceed 80% battery usage.

STORAGE: 

Store your battery pack/s in a LiPo Sack (GPMP0751) 

or other LiPo safety container. It is also best to store them in a cool 
dry place and on a fire resistant surface. It is best to charge your 
batteries to either a full charge (if you feel you will be using the packs 
frequently) or at or around 50% rated capacity for longer storage.

WARRANTY SERVICE

AquaCraft will warrant your model for 90 days after the purchase 
from defects in materials or workmanship of original manufacture. 
AquaCraft, at their option, will repair or replace at no charge, 
the incorrectly made part. This warranty does not cover damage 
caused by crash, abuse, misuse, alteration or accident. To return 
your boat for service you need to provide proof of purchase. Your 
store receipt or product invoice will suffice. 

IN NO EVENT SHALL 

THE PURCHASER BE ENTITLED TO ANY INCIDENTAL, SPECIAL, 
INDIRECT OR CONSEQUENTIAL DAMAGES, WHETHER RESULTING 
FROM THE USE, MISUSE OR INABILITY TO USE THE PRODUCT OR 
FROM DEFECTS IN THE PRODUCT. 

This warranty gives you specific legal rights and you may also have 
other rights, which vary from state to state.

Outside USA and Canada, contact local importer for warranty 
information.

Hobby Services 

3002 N. Apollo Drive, Suite 1

Champaign, Illinois 61822

Attn: Service Department

Phone: (217) 398-0007 9:00 am - 5:00 pm Central Time M-F

E-mail: [email protected]

Summary of Contents for mini mono













Reviews: