9
SHARPENING:
It’s best to sharpen the turn fins to a ra-
zor sharp edge. This will eliminate drag and reduce lift.
Remember as a rule of thumb, if it touches the wa-
ter it needs to be sharp or have sharp edges
TRIM PLATES:
Bending the trim plates up or down controls
the ride of the boat. The trim plates help control porpoising.
Porpoising is when the boat bounces up and down as it runs
over the water. Keep in mind bending the trim plates down
too far can have negative results, causing the boat to draw
too much power and possibly damage the electronics.
ORDERING REPLACEMENT PARTS
To order replacement parts for the AquaCraft Minimono use the order numbers in the replacement parts list that follows. Replacement parts
can be purchased from your local hobby shop or by mail order. If you need assistance locating a dealer to purchase parts, vist hobbico.com
and click on “Where to buy”. If you are missing parts, contact Hobbico Product Support at:
Phone:
217.398.8970
Fax:
217.398.7721
E-mail:
AQUB6234 Cowl
AQUB6267
Wire Drive with Prop Shaft
AQUB8752
Rudder Linkage Set
AQUB7907 Motor
Coupler
AQUB9281
Turn Fin Plates
AQUG7003 Brushless
Motor
AQUM3530
20-Amp LiPo Controller
AQUB8742
Rudder Support Brackets
AQUB8735
Rudder Assembly Complete
AQUB8736 Rudder
TACJ0300
TTX300 Radio System
