Copyright © 2014 Aqua Creek Products All Rights Reserved
Revised 12/11/14
V:1.0
1.9" X 6" ANCHOR
(AQUA CREEK OR EQUIVALENT)
SCOUT MAIN ASSEMBLY
1.9" POST
FIXING ANCHOR-TAB
1/2" X 2"
HEX BOLT &
FLAT WASHER
1" X 4"
FIXING-
ANCHOR
ANCHOR MUST BE BONDED
ACCORDING TO LOCAL
REQUIREMENTS
FIGURE A
Scout Assembly Instructions
WARNING:
NEVER LIFT THE MAIN ASSEMBLY
USING THE LINEAR ACTUATOR AS A HANDLE! LIFT THE
ASSEMBLY FROM THE ENDS. USE AT LEAST 2 PEOPLE TO
LIFT. USE TRANSPORT CART IF AVAILABLE.
NOTE: Be careful not to over-tighten bolts.
Over-tightening can cause damage and
compromise the safety of your lift.
1.
Lift the Scout
MAIN ASSEMBLY
from the shipping container.
1/2" X 2-3/4" SHOULDER BOLT
3/8" X 2" SHOULDER
BOLT
3/8" FLAT WASHER
3/8"-16 NYLOCK NUT
SCOUT LIFTING ARM
(LONG END: SEE NOTE)
LINEAR
ACTUATOR
5/16"-18 NYLOCK NUT
5/16" FLAT WASHER
("B" END: SEE NOTE)
A
B
B
D
FIGURE B
PHOTO 1
PHOTO 2
NOTE: The LIFTING ARM is easily flipped
around the wrong way. Make sure the end
marked “B” is towards the mast, as shown.
Insert the 1.9” [48mm] post of the
MAIN ASSEMBLY
into the deck anchor (
FIGURE A
). Ease the
MAIN ASSEMBLY
down until it rests on the pool/spa deck surface. Rotate the base until the
fixing anchor-tab lines-up with the fixing anchor. Install the ½” x 2” hex bolt & washer to hold
down the lift. Tighten the bolt.
2.
Remove the shipping strap and all
packing from the
ACTUATOR
. Connect
the
LIFTING ARM
between the mast and
the
ACTUATOR
(FIGURE B)
. Tighten nylock
nuts
(PHOTO 1 & PHOTO 2)
.
TOOLS REQUIRED:
1/2” WRENCH
3/16” ALLEN WRENCH
9/16” WRENCH
1/4” ALLEN WRENCH
3/4” WRENCH
8
