V:1.0
Copyright © 2014 Aqua Creek Products All Rights Reserved
Revised 12/11/14
V:1.0
Scout Assembly Instructions (cont.)
1/2" X 3" SHOULDER BOLT (2)
3/8"-16 NYLOCK NUT (2)
3/8" FLAT WASHER (2)
CHAIR-ARM ASSEMBLY
C
C
D
D
FIGURE D
PHOTO 3
PHOTO 4
PHOTO 5
NOTE: Make sure the letters match up; with the
chair facing away from the main assembly.
NOTE: Flip the CONTROL ARM (upper arm) out
of the way while the LIFTING ARM (lower arm) is
attached first. This makes it easier to line-up the
holes.
3.
Install the
CONTROL ARM
(“A” END,
FIGURE C)
onto the mast as shown in
the figure above. Tighten the nylock nut
(PHOTO 3)
.
4.
Install the
CHAIR ARM
at the ends of the
LIFTING ARM
and
CONTROL ARM
(FIGURE D)
.
Tighten the nylock nuts
(PHOTOS 4 & 5)
.
5.
Remove the fully charged
BATTERY
from
the charger, grease the battery and control box
terminals, and install the battery on top of the
control box. The battery will line up square with
the control box, and will ‘click’ when it locks in
place properly. The lift will only operate when the
battery is mounted properly.
WHEN LIFT IS NOT IN SERVICE, STORE BATTERY
ON THE CHARGER!
FIGURE C
1/2" X 2-3/4" SHOULDER BOLT
3/8"-16 NYLOCK NUT
3/8" FLAT WASHER
SCOUT CONTROL ARM
A
B
B
A
"A" END
9
