Copyright © 2014 Aqua Creek Products All Rights Reserved
Revised 12/11/14
V:1.0
CHAIR ARM
ADJUSTMENT
HOLES IN 4"
INCREMENTS
(16" ADJ. RANGE)
CHAIR ADJUSTED
TO LOWEST POSITION
(CHAIR WILL ARRIVE
IN HIGHEST POSITION)
Scout Assembly Instructions
The CHAIR ASSEMBLY will arrive attached to the CHAIR ARM adjusted to its highest position.
To adjust the CHAIR ASSEMBLY to a lower position remove the hardware as shown below. Slide
the SEAT ASSEMBLY to its desired position (in 4” increments) and reinstall the hardware. The
maximum adjustment is 16” (down).
DO NOT ATTACH THE CHAIR ASSEMBLY ANY LOWER THAN THIS – ALWAYS USE THE TWO (2)
SUPPLIED HEX BOLTS TO ATTACH THE CHAIR ASSEMBLY TO THE CHAIR ARM!
NOTE: For most applications, such as pools with a flat deck, the seat will be installed in its lowest
position. For applications where a wall or curb must be cleared the seat should be installed in a
higher position. In its highest position the seat will clear a 28” [777mm] high wall.
3/8" X 2-1/2"
HEX BOLT
5/16" X 3-1/2"
HEX BOLT
5/16" NYLOCK
NUT
3/8" NYLOCK
NUT
3/8" FLAT
WASHER
5/16" FLAT
WASHER
5/16" FLAT
WASHER
3/8" FLAT
WASHER
10
