CHAPTER 4
REMOTE CONTROL PROGRAMMING
Entire Contents Copyright
2014 by Adaptive Power Systems, Inc. (APS) • All Rights Reserved • No reproduction without written authorization from APS.
44M04 LOAD MAINFRAME OPERATIONS MANUAL
Page 73 of 93
44M00
[STATe:] CCR {AUTO | R2}
Command Syntax:
[STATe:] CCR {AUTO | R2} {; | NL}
Purpose:
This command sets the CC MODE RANGE, forcing RANGE II operation if required.
Description:
Switches the unit between AUTO RANGE and RANGE II. AUTO RANGE will allow
the unit to move to a more precise range at low currents, while forcing the unit to remain
in RANGE II keeps the range consistent regardless of the current level.
[STATe:] POLAR {POS | NEG}
Command Syntax:
[STATe:] POLAR {POS | NEG} {; | NL}
Purpose:
Sets the polarity displayed by the voltage meter.
Description:
The voltage read-out can be set to POS for positive, and NEG for negative polarity
display.
[STATe:] START
Command Syntax:
[STATe:]START {; | NL}
Purpose:
Set for load to begin the test.
Description:
Begins the test, according to the TEST CONFIG (TCONFIG). The load module will start
to test based on the items and parameters stored.
[STATe:] STOP
Command Syntax:
[STATe:]STOP {; | NL}
Purpose:
Stops a test, if one is in progress.
