continued from the previous page
Parameters
Range
x:
day of the week code
[0 – 9]
0:
Monday
1:
Tuesday
2:
Wednesday
3:
Thursday
4:
Friday
5:
Saturday
6:
Sunday
7:
Weekdays
8:
Weekends
9:
Everyday
y:
event code
4-events per day configuration
[0 – 3]
0:
Wake
1:
Leave
2:
Return
3:
Sleep
2-events per day configuration
[0 – 1]
0:
Wake/Occupied
1:
Sleep/Unoccupied
hh:
event start time hours in 24-hour format
[00 – 23]
mm:
event start time minutes
[00 – 59]
HT:
event heat setpoint
Fahrenheit
[40 – 90]
Celsius
[4 – 32]
CL:
event cool setpoint
Fahrenheit
[42 – 99]
Celsius
[6 – 37]
fan:
event programmed fan mode
[AUTO, A, ON, CIRC]
AUTO, A:
fan auto mode
ON:
fan on mode
CIRC:
fan circulate mode
scale:
temperature scale
[F, C]
F:
Fahrenheit
C:
Celsius
The thermostat schedule is divided into 7 days with a maximum of 4 events per day . Access to the schedule is on a per-event basis . Each
event has a start time, heat and cool setpoint and a fan mode . When an assignment command is received, the specified event(s) are
automatically stored in non-volatile memory .
If an assignment command is received with a day of the week code
[x]
parameter of 7-9, the event
[y]
for each day corresponding to the
day of the week code
[x]
is configured with the parameters of the command (assuming correct syntax, etc .) .
If a query command is received with a day of the week code
[x]
parameter of 7 or 9, the event configuration of Monday is sent; if the
parameter is 8, the event configuration of Saturday is sent .
If the thermostat is configured for 2 events per day, commands received with the event
[y]
parameter greater than 1 is ignored . If the
thermostat is configured with a Control Setup of Heat Only or Cool Only, only the respective setpoint is used in the command syntax .
This command is ignored if the controller type is set to humidistat or if the thermostat is configured as non-programmable . In addition,
commands with a day of the week code in conflict with the program format are ignored . (E .g . if the thermostat is configured with a program
format of 5/2 and a day of the week code of 0-6 is received, the command is ignored since the thermostat cannot program days individually in
the 5/2 program format .)
Integer values must be within the ranges specified . The schedule can be changed through the thermostat Program Screens . If the schedule is
changed at the thermostat, a C16 COS unsolicited message is issued (if C16 is ON) . NOTE: if the schedule is changed at the thermostat, up to
4 COS unsolicited messages can be sent (one for each event in a day) .
47
