11
9-1-2022
APQS.com
Lucey Deluxe Installation
Leg Box (Boxes 5 & 6)
1.
Tilt each box on its side to make it easier to pull each leg out of the box (opening box so “up” stamped on
box is horizontal). Discard any packing sleeves on the base of each leg.
2.
Adjust Leg Height.
a.
Measure the distance between the front roller support to your naval or as your arm bends
straight across your body. Each of the four leg adjusting rods should be moved to this height.
Once the table is assembled completely, you can make minor adjustments if needed.
b.
Loosen the leg jam nut with the leg wrench; the leg wrench is included in shipping contents.
c.
Once you have loosened the leg jam nut with the leg wrench, you can turn the threaded leg
counterclockwise to extend the leg to the correct distance. Re-tighten the jam nut when you are
at your desired height. Repeat the process for each leg.
Measure from the floor to your naval as your arm crosses your mid-section across your body. This
is the height your table legs should be set to on the first roller (Backing Roller).
1.
Leg Jam Nut
a.
Use the large black leg wrench that is
included in your shipping boxes
2.
Threaded Leg
3.
¾” Nut
3.
To adjust the leg
levelers, loosen the
leg jam nut
directly underneath
the leg with the leg
wrench.
4.
Place a ¾ - inch open-
end wrench (or
crescent wrench) on
the foot pad nut. Turn
the nut clockwise to
lower the leg;
counterclockwise will
raise the leg.
5.
When the table is
level in all
directions, tighten
the jam nut
against the top of
the leg with the
leg wrench.
