23
Fig.16
Make sure that rail channel is clean of debris.
Check the clearance and movement of the jacking beam by sliding it forward and rearward on the rails.
Connect the pneumatic line following the instruction on the chapter 7.10.
Connect the hydraulic hose.
Without a vehicle loaded, raise the jack at full stroke to check for the proper operation.
Check for the safety operation by lowering the jack.
CHAPTER 8 - OPERATION AND USE
Never operate the lift with any person or equipment below.
Never exceed the rated lifting capacity.
Always ensure that the mechanical safeties are engaged before any attempt is
made to work on or near the vehicle.
Never leave the lift in an elevated position unless the safeties are engaged.
If an anchor bolt becomes loose or any component of the lift is found to be
defective, DO NOT USE THE LIFT until repairs are made.
8.1 CONTROLS OF LIFT
Controls for operating the lift are: